1. Read these instructions - for all components
before using this product.
2. Keep these instructions -
for
future reference.
3.
Heed all warnings - on the product and
in
the
owner's guide.
4. Follow all instructions.
5.
Do not use this apparatus
near
water
or
moisture - Do
not
use this
product
near a
bathtub, washbowl, kitchen sink, laundry tub,
in
a
wet
basement, near a swimming pool,
or
any-
where else that water
or
moisture are present.
6. Clean only with a dry cloth - and as directed
by
80se® Corporation. Unplug this product from
the wall outlet before cleaning.
7. Do not block any ventilation openings.
Install in accordance with
the
manufacturer's instructions -
To
ensure
reliable operation
of
the product and
to
protect it
from overheating,
put
the product in a position
and location that will not interfere with its proper
ventilation. For example,
do
not place the product
on a bed, sofa,
or
similar surface that may block
the ventilation openings. Do
not
put
it
in
a built-in
system, such as a bookcase
or
a cabinet that may
keep air from flowing through its ventilation
openings.
8.
Do not install nearany heat sources, such
as radiators, heat registers, stoves or other
apparatus (including amplifiers)
that
pro-
duce heat.
9. Do not
defeat
the
safety purpose
of
the
polarized
or
grounding-type plug. A polar-
ized plug has
two
blades with one wider
than
the
other. A grounding-type plug has
two blades and a third grounding prong. The
wider blade
or
third prong
are
provided for
your safety.
If
the
provided plug does not fit
in your outlet, consult an electrician for
replacement
of
the
obsolete outlet.
10. Protect
the
power cord from being walked
on
or pinched, particularly
at
plugs, conve-
nience receptacles, and
the
point where
they exit from
the
apparatus.
11. Only use attachments/accessories speci-
fied by
the
manufacturer.
12.
Use only with
the
cart, stand, tripod,
bracket
or
table specified by
the(l)
manufacturer
or
sold with
the
tim
apparatus. When a
cart
is used, •
use caution when moving
the
~
cart/apparatus combination to
~
~
avoid injury from tip-over.
~
13. Unplug this apparatus during lightning
storms
or
when unused for long periods
of
time -
to
prevent damage
to
this product.
14. Refer all servicing to qualified service person-
nel. Servicing is required when
the
apparatus
has been damaged in any way: such as power-
supply cord
or
plug is damaged; liquid has
been spilled or objects have fallen into
the
apparatus;
the
apparatus has been exposed to
rain
or
moisture, does not operate normally, or
has been dropped -
Do not attempt
to
service this
product yourself. Opening
or
removing covers may
expose you
to
dangerous voltages orother hazards.
Please call
80se
to
be referred
to
an
authorized
service center near you.
15.
To
prevent risk of fire or electric shock, avoid
overloading wall outlets, extension cords,
or
integral convenience receptacles.
16. Do not
let
objects or liquids
enter
the
product -
as they may touch dangerous voltage points
or
short-out parts that could result in a fire
or
electric
shock.
17.
See product enclosure bottom for safety
related markings.
Information
about
products
that
generate
electrical
noise
If applicable, this equipment has been tested and found
to
comply with the limits for a Class 8 digital device,
pursuant
to
Part
15
of
the FCC rules. These limits are
designed
to
provide reasonable protection against
harmful interference
in
a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used
in
accor-
dance with the instructions, may cause harmful interfer-
ence to radio communications. However, this is no
guarantee that interference will not occur
in
a particular
installation. If this equipment does cause harmful interfer-
ence
to
radio
or
television reception, which can be
determined by turning the equipment off and on, you are
encouraged
to
try to correct the interference by one or
more
of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment
to
an outlet on a different
circuit than the one
to
which the receiver is connected.
• Consult the dealer or
an
experienced radiolTV techni-
cian for help.
Note:
Unauthorized modification
of
the receiver
or
radio
remote control could void the user's authority
to
operate
this equipment.
This product complies with the Canadian ICES-003 Class
8 specifications.
To Next Page
Loading...
