20 - English
Mounting the adapter
You can mount the adapter on a wall (hardware not included). If your mounting
hardware comes with instructions that differ from these instructions,
follow the instructions supplied with your hardware.
This table describes mounting hardware specifications.
Item Wood Wallboard
Wall thickness
3
⁄4 in. (19 mm) or thicker
3
⁄8 in. (9.5 mm) or thicker
Drill bit
1
⁄8 in. (3 mm)
3
⁄16 in. (4.5 mm)
Pan-head wood screws (2)
#8 x 1
1
⁄4 in. (32 mm) #8 x 1
1
⁄4 in. (32 mm)
Plastic wall anchors (2)
Not used #6 - 8 x 1 in. (25 mm)
Mounting options
There are two ways to mount the adapter:
• Vertically; connector panel facing left
• Horizontally; connector panel facing up
To mount the adapter
1. Drill two holes 6 ¼ in. (159 mm) center-to-center.
2. Insert plastic wall anchors (if mounting to wallboard).
3. Install pan-head wood screws.
Note: Leave the screw heads ¼ in. (6.35 mm) above wall surface.
4. Position adapter onto the screws.
Appendix B: Mounting the Wireless Adapter
To Next Page
Loading...
