CONFIRMING
OPERATION
Check
the
indicators
and
settings
Before you use this addition to the audio link, you may want
to
check some
of
the indicators and settings that make your
expansion products work together smoothly.
The
Status
LED
On
the connection panel of both the transmitter and the
receiver, the Status
LED
indicates how the two units are
communicating,
as
shown
in
the table below.
Status
LED
On
the
transmitter
On
the
receiver
Blinking Solid
Green Green
Searching Receiver
for receiver located
Searching for Solid signal
transmitter received
Blinking
Orange
Not
applicable
Weak signal
received
Solid
Orange
Powered on,
no communication
Weak or no signal
received
8
On
the receiver, a blinking or solid orange light indicates a
communications problem. Repositioning the transmitter or
receiver, or both, may resolve the problem and cause both
LEDs to change
to
solid green. For further information, refer
to
"Troubleshooting" on page
9.
Your Bose® link expansion room
remote
control
• Room code
If you have more than one
LI
FESTYLE®
system expansion
room set up, make sure the remote used
in
each one has a
unique room code.
• House code
The house code setting on the remote must match the set-
ting on your
L1FESTYLE®
system. This is
an
issue only if you
have changed the system house code due
to
interference
with another Bose
L1FESTYLE®
system.
For information on these house code and room code settings
and
how
to
change them, refer
to
the owner's guide that came
with your remote.
J
Note:
Setup codes for the ALB transmitter
and
AR1 receiver,
which
must
be
identical to each other,
do
NOT
need to
match
house codes on the remote
or
LIFESTYLEID
system.
To Next Page
Loading...
Need help?
General
