Bose Solo 5 - Page 31

31
TERA TERM COMMAND SETUP
Required Items
1. TeraTerm terminal emulator - download at
http://sourceforge.jp/projects/ttssh2/
2. TAP Cable part number 264565
3. RS232-TTL Converter - B&B electronics Model
232LPTTL or similar - http://bb-elec.com
Setup
1. Connect the TAP cable, using a RS232-TTL
converter, to your computer’s COM port then to
the unit’s DATA connector located under the label
on the unit back.
2. Select COM Port
3. Select Serial Port
4. Set Serial Port
Baud: 115200, Data bits: 8, Parity: No, Stop bit: 1
5. Select Terminal
6. Set Terminal to “Local echo” - Click “ OK”
7. Set Terminal to “Local echo” - Click “ OK”.
The TAP prompt will present a banner when it is
ready to accept a command:
“\n\rGO>” for normal operation.
“\n\rGO#” for manufacturing mode.