33
DISASSEMBLY PROCEDURE
T4S Mixer
1. Bottom Housing Removal
1.1 Place the T4S onto a soft surface. Remove
the four feet and the one rubber screw cover,
located near the product label. See photo at right.
Remove the ve screws that secure the bottom
housing to the top housing.
Note: It is recommended to replace the feet with
new ones after removal. Be sure to remove all of
the old adhesive before installing the new feet.
1.2 At the bottom front edge of the unit near the
volume controls, carefully separate the bottom
housing from the top housing. Lift off the bottom
housing. Take care to not damage the plastic
housing.
2. Input / Output PCB Removal
2.1 Perform procedure 1.
2.2 Remove the twelve screws that secure the
RJ45 and Neutrik
®
XLR/TRS jacks to the I/O
panel.
2.3 Carefully angle the I/O PCB out of the rear
panel. Disconnect the two ribbon cables that
connect to the main PCB. Lift off the I/O PCB.
To Next Page
Loading...
