Boss GT-6 User Manual (English)

Read This First

Achieving the Optimum

Settings for Your Setup

Your connections/Output Select settings need to be

configured so they’re appropriate for your operating

environment, as explained below.

To make settings for Output Select, press the OUTPUT

SELECT button to display the “Output Select” settings

screen, then rotate the PATCH/VALUE dial.

For more details, refer to p. 14 in the Owner’s Manual.

fig.001

* This is set to “COMBO AMP” when shipped from the factory.

* When using an amp with switchable channels, select the

NORMAL (CLEAN) channel. If the inputs are labelled L

and H, use L.

■ When connecting to the Roland JC-120’s

NORMAL input

Output Select: JC-120

fig.002

■ When connecting to a small practice amp

Output Select: SMALL AMP

fig.003

■ When connecting to a combo amp’s

NORMAL input

Output Select: COMBO AMP

fig.004

■

When connecting to a stack amp’s NORMAL input

Output Select: STACK AMP

fig.005

■ When connecting to a combo amp’s

RETURN or MAIN IN

Output Select: COMBO RETURN

fig.006

■ When connecting to a stack amp’s RETURN

or MAIN IN

Output Select: STACK RETURN

fig.007

■ When using headphones or conducting

recording (direct in)

Output Select: LINE/PHONES

■ When connecting to a P.A. or mixer

Output Select: LINE (P.A.)

If You Want to Make Some Finer

Adjustments

You can adjust the tonal quality in the “GLOB: LowEQ” and

“GLOB: HighEQ” screens.

You can select these settings screens by pressing the UTILITY

button and then the PARAMETER buttons.

fig.008

For further details, refer to p. 59 in the Owner’s Manual.

INPUT

RETURN

MAIN IN

RETURN or MAIN IN

any form without the written permission of BOSS CORPORATION.

Need help?

Do you have a question about the Boss GT-6 and is the answer not in the manual?

Boss GT-6 Specifications

General

A/D Conversion	24-bit
D/A Conversion	24-bit
Sampling Frequency	44.1 kHz
Nominal Input Level	-10 dBu
Nominal Output Level	-10 dBu
Expression Pedal	Built-in
Display	LCD
Type	Guitar Effects Processor
Input Impedance	1 MΩ
Dynamic Range	100 dB
Connectors	MIDI connectors (IN/OUT)
Power Supply	AC Adaptor
Inputs	Guitar Input
Outputs	2 (L/Mono, R)
Effects	Compressor, Overdrive/Distortion, Wah, Tone Modify, Equalizer, Noise Suppressor, Slow Gear, Defretter, Wave Synth, Sitar Simulator, Octave, Pitch Shifter, Harmonist, Tremolo/Pan, Phaser, Flanger, Rotary, Chorus, Delay, Reverb
Output Impedance	2 k ohms