Basic Operation
11
English Deutsch Français Italiano Español Português Nederlands
Display
Play Stop Explanation
oS
One-shot
playback
Stop
imme-
diately
One-shot playback will play
the phrase once from the
beginning to the end, and
then stop automatically.
* Overdubbing is disabled
when one-shot playback
is in eect. If the left pedal
is pressed during playback
of the phrase, the phrase
starts playing from the
beginning again (retrigger
playback).
Fo
Loop
play
Fade-
out and
then
stop
The stop eect will be applied
when you press the right
pedal.
• The PLAY indicator will blink
until the phrase stops.
• You can stop immediately
by pressing the right pedal
once again before the
phrase has stopped.
* You can’t overdub before
the phrase has stopped.
LE
Loop
play
Play to
the end
of the
phrase
and
then
stop
3. Press the [SELECT] button to return to
normal operation.
The stop mode setting is remembered when you save
the phrase (p. 10).
Cancelling an Overdub
(Undo/Redo/Track Clear)
You can Undo/Redo by holding down the left pedal for two
seconds or longer. You can clear the track by holding down
the right pedal and pressing the left pedal.
Operation
Display
Explanation
Undo
Un
Hold down the left pedal for at least
two seconds during playback or
overdubbing; the recording or the
most recent overdubbing will be
cancelled.
Redo
rE
If you want to restore the cancelled
sound, hold down the left pedal for
at least two seconds while playback
once again.
* Redo is only available for
overdubbing.
Operation
Display
Explanation
Track
clear
CL
If you hold down the right pedal and
press the left pedal while both tracks
1 and 2 are stopped, the phrase of the
current track will be cleared. (Clear is
temporary; phrases saved in phrase
memory will not be deleted.)
* Make sure to press the right pedal
rst, then press the left pedal.
During Undo/Redo, the PLAY and REC indicators will blink
rapidly. During Clear, the PLAY indicator will blink rapidly.
Auto Recording/Count-In
Recording Functions
“Auto recording” starts recording the moment you begin
playing your guitar or play back your audio player. “Count-in”
sounds the rhythm for one measure before recording starts.
1. Hold down the [TAP TEMPO] button for
at least two seconds.
The display will indicate “no.”
2. Use the [ ] / [ ] buttons to select the
desired recording mode, and then press
the left pedal to start recording.
Display
Mode Explanation
no
Normal
recording
Recording will begin the instant you
press the left pedal.
AU
Auto
recording
The REC indicator will blink rapidly,
and the RC-30 will enter recording-
standby mode. When you begin
playing, the REC indicator will light
and recording will start.
Ct
Count-in
recording
The [RHYTHM ON/OFF] button will
blink. When you press the left pedal,
the REC indicator will blink rapidly,
and the rhythm will sound for one
measure. (You can stop by pressing
the right pedal during this time.)
When the one measure of playback
has ended, recording will start. (The
rhythm will continue sounding even
after recording has begun.)
For more about the rhythm settings,
refer to “About Rhythm” (p. 12).
The recording mode will be reset to Normal recording when
you turn o the power.
To Next Page
Loading...
