Need help?Do you have a question about the Boss RIOT RT445 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Impedance | 2-8 Ohms |
| Gain Control | Yes |
| EQ Controls | Bass Boost |
| THD at RMS Output | 0.01% |
| Minimum Speaker Impedance | 2 Ohms |
| Bass Boost | Yes |
| Bass Boost Frequency | 45 Hz |
| Inputs | RCA |
| Outputs | Speaker Terminals |
| RMS Power @ 4 Ohms | 45 Watts x 4 |
| Signal-to-Noise Ratio | 90 dB |
| Frequency Response | 10 Hz - 45 kHz |
| Crossover Type | Low-pass, High-pass |
| Low-Pass Crossover Frequency | 50 Hz to 250 Hz |
Details features for 2-channel, 4-channel, 5-channel, and monoblock amplifiers.
Explains crossover types and bass boost for different amplifier models.
Details the advantages and requirements of 2 Ohm operation.
Explains the amplifier's protection modes, LED indicators, and reset procedures.
Covers power, ground, remote connections, and fuse importance.
Guides on marking, drilling, and safe mounting locations.
Illustrates high-level input and remote subwoofer level control wiring for 2/4 channel amps.
Shows high-level input wiring and explains mode switch settings for the 5-channel amp.
Depicts low-level RCA input wiring for monoblock, 2-channel, and 4-channel amplifiers.
Illustrates wiring for the 5-channel amplifier in 4CH and 5CH modes.
Shows single channel, stereo, and bridged wiring for 2-channel amplifiers.
Explains tri-mode operation with crossover components and wiring for 2-channel amps.
Shows standard 4-channel speaker wiring and bridged wiring.
Details dual tri-mode setup with crossover components and wiring for 4-channel amps.
Shows standard 5-channel speaker wiring and bridged wiring.
Explains dual tri-mode setup with crossover components and wiring for 5-channel amps.
Advises careful layout investigation before drilling near fuel or lines.
Warns against operating unmounted or in pinched/damaged wire conditions.
Instructs to disconnect battery and use identical fuses for safety.
Guides on checking connections, fuses, and signal source for output problems.
Suggests adjusting level control and checking grounding for noise issues.
To Next Page
