Boss TPSE101 - User Manual

To Next Page

Instruction Manual

TPSE201 (181422) - BOSS

Universal Programmer

TPSE101 (569565) - BOSS

Universal Timeswitch

Thank you for purchasing this product. If installing for someone else, please ensure that the

instructions are handed to the householder.

Please read this manual prior to installation or use. Retain for future reference.

Always isolate the mains supply before removing the unit from the backplate.

Please leave these instructions with the end user where they should be kept in a safe place for

future reference

Installation

The TPSE201/TPSE101 is easily installed using the backplate supplied. This can be mounted directly to

the wall or a single gang recessed box using the holes provided; cable entry is from the rear.

Speciﬁcation

Power supply 230V/50Hz

Switch rating 6(2)A

Switch type Single pole, double throw (SPDT)

Operating temperature 0°C - 50°C

Storage conditions -20°C - 60°C

Frost protection temperature 5°C

Programme

5/2, 7 day or daily selectable by jumper

3 setting per day

Time display 12 or 24 hour

Memory Internal memory back-up

Backlight Green LED

Switches/Jumpers

The installer should select the jumper positions required if changing from the factory pre-sets, these

jumpers are found on the rear of the unit. Always enable the internal memory back up battery before

installing the unit,

Switch/Jumpers Function

Program type

3x2 pins jumpers for 5+2 days (factory default setting),

7 days program or daily

P/G (TPSE201 only)

3x1 pin jumper for fully pumped and controlled system

(factory default setting) or gravity-fed hot water system.

Internal backup battery

3x1 pin jumper to enable/disable the internal backup

battery (disabled is the factory default setting)

Need help?

Do you have a question about the Boss TPSE101 and is the answer not in the manual?

Summary

Installation Procedure

Technical Specifications

Details electrical and operational parameters of the unit, including power supply and temperature ranges.

Switches and Jumpers Configuration

Configuration options for program type and system setup using internal jumpers.

Backplate and Wiring Guide

Terminal Connections Explained

Identifies connection points for TPSE101 and TPSE201 models, including N, L, and heating/hot water terminals.

User Instructions

Keyboard Functions

Initial Power Up and Reset

Setting the Clock

Programming 5-2 Day Schedules

Programming 7 Day Schedules

Programming Daily Schedules

Operating Mode Selection

Explanation of Operating Modes

Temporary Program Overrides

Hr+ Program Override Function

Allows temporary manual adjustment of heating or hot water programs by hour.

Advance Program Override

Backup Battery Management