8
TRAMPOLINE PLACEMENT
For safe use of the trampoline, please be aware of the following when selecting the place for your trampoline:
• Make sure it is placed on a level surface.
• The area is well lit.
• There are no obstructions beneath the trampoline.
• The minimum overhead clearance required is 7 metres. Ensure that there are no overhead hazards such as
tree limbs or electrical power wiring.
PLEASE READ THESE ASSEMBLY GUIDELINES BEFORE STARTING TO
ASSEMBLE THE TRAMPOLINE. INCORRECT ASSEMBLY WILL CAUSE DAMAGE
TO THE TRAMPOLINE FRAME.
1. Make sure the trampoline is placed on level ground. Uneven ground surfaces may cause the trampoline
frame to warp.
2. Make sure that all bolts holding the frame joints are tightened completely before installing the springs.
Failure to do this properly will cause the frame to warp.
3. Make sure NOT to use one’s leg to push against the trampoline leg or frame when loading the springs.
It will cause the trampoline to warp.
4. DO NOT load the springs onto the frame on only one side of the trampoline. Uneven distribution of tension
from the springs will cause the frame to warp.
5. If the trampoline frame warps up, do not be alarmed as the “Quad-lock” system is designed to be exible.
Push down on the part of the frame that warped with two people as shown. The frame will level out.
#18M12BK003 10 FOOT UM.indd 8 2018/12/20 3:10 PM
To Next Page
Loading...