Need help?Do you have a question about the Bowers & Wilkins DM 601 S2 and is the answer not in the manual?
Drive Units| bass/mid unit size | 180 mm (7 in) |
|---|---|
| high-frequency unit size | 26 mm (1 in) |
| bass/mid unit material | woven Kevlar[®] cone |
Frequency| frequency range | -6dB at 43Hz and 30kHz |
|---|---|
| frequency response | 52Hz - 20kHz ±3dB on reference axis |
Sensitivity and Distortion| sensitivity | 90dB spl (2.83V, 1m) |
|---|---|
| harmonic distortion | <1% 60Hz - 20kHz (90dB spl, 1m) |
Impedance and Crossover| nominal impedance | 8 Ω (minimum 4.3 Ω) |
|---|---|
| crossover frequency | 4kHz |
| max. recommended cable impedance | 0.1 Ω |
Power Handling| power handling | 25W-120W continuous into 8 Ω on unclipped programme |
|---|
Weight and Dimensions| height | 490 mm (19.3 in) |
|---|---|
| width | 236 mm (9.3 in) |
| depth | 306 mm (12 in) |
| weight | 9.8 kg (21.6 lb) |
Drive Units| bass/mid unit size | 165 mm (6.5 in) |
|---|---|
| high-frequency unit size | 26 mm (1 in) |
| bass/mid unit material | woven Kevlar[®] cone |
Frequency| frequency range | -6dB at 50Hz and 30kHz |
|---|---|
| frequency response | 70Hz - 20kHz ± 3dB on reference axis |
Sensitivity and Distortion| sensitivity | 88dB spl (2.83V, 1m) |
|---|---|
| harmonic distortion | <1% 88Hz - 20kHz (90dB spl, 1m) |
Impedance and Crossover| nominal impedance | 8 Ω (minimum 4.3 Ω) |
|---|---|
| crossover frequency | 4kHz |
| max. recommended cable impedance | 0.1 Ω |
Power Handling| power handling | 25W-100W continuous into 8 Ω on unclipped programme |
|---|
Weight and Dimensions| height | 356 mm (14 in) |
|---|---|
| width | 204 mm (8 in) |
| depth | 244 mm (9.6 in) |
| weight | 6.1 kg (13.4 lb) |
Keep magnetically sensitive articles at least 0.5m from the speaker to avoid interference.
To Next Page