BOWHEAD REACH - Wheels & Tires

26 | P a g e
Fasteners
• Ensure all fasteners are correctly tightened according to the specifications in “Tools
and recommended torque values” on page 10-12.
• Check that the fasteners on any accessories you’ve added are properly tightened
according to the manufacturer’s instructions.
Brake system
• Check brake pads and ensure the brake pad material isn’t thinner than the backing
plate it attaches to.
• Ensure brake pads are correctly positioned in relation to the brake rotors.
• Ensure brake cables are lubricated, correctly adjusted, and show no obvious wear.
• Ensure brake levers are properly positioned and tightly secured to the handlebar.
• Use the techniques in “Checking brakes” on page 29 to test the brake levers, and
brakes.
Wheels & Tires
• Ensure tires are holding air and inflated to within the recommended limits displayed
on the tire sidewalls.
• Ensure tires have good tread, have no bulges or excessive wear, and are free from any
other damage.
• Ensure rims run true and have no obvious wobbles, dents, or kinks. Contact Bowhead
for support if unsure how to perform.
• Check each wheel spoke. If any are loose or broken, seek help from a certified,
reputable mechanic.
• Check the rear axle on the rear wheel to ensure it is correctly tightened with the axle
pin securing it in place (see “Tools and recommended torque values” on page 12).
Steering
• Ensure the handlebar and stem are correctly aligned, adjusted, and tightened for
proper steering.
• Perform a handlebar twist test to ensure the stem clamp bolt is secure. See
“Handlebar twist test” on page 31.
• Ensure the handlebar is set correctly in relation to the wheels and the direction of
travel.
• Ensure the handlebar grips are secure and undamaged.
Bearings & Bushings
• Check that headset, wheel, suspension bearings are lubricated, run freely, and display
no excess movement, grinding, or rattling.
• Check that the front articulation and steering bearing are intact and display no
obvious signs of damage or excess wear.