Bradco BC72 - Page 2

9115 10-11-06-3
SERVICE
When servicing your rotary cutter, remember to use only manufacturer replacement
parts. Substitute parts may not meet the standards required for safe, dependable operation.
To facilitate parts ordering, record the model and serial number of your unit on the
cover or in the space provided on this page. This information may be obtained from the iden-
tication plate located on the right front of the mounting plate.
MODEL____________________________________
SERIAL NUMBER___________________________
DATE PURCHASED_________________________
The parts department needs this information to ensure that you receive the correct
parts for your specic model.
READ ENTIRE OPERATOR'S & PARTS MANUAL BEFORE OPERATING!
DANGER! ROTATING BLADE HAZARD! STAY BACK!
OBJECTS CAN BE THROWN!
DO NOT operate near bystanders.
DO NOT place hands or feet under deck while in operation or with engine
running.
DO NOT operate without a shatterproof door (or front shield) installed on
loader.
WARNING! Before leaving the operator's seat: Lower the lift arms against frame and
place unit on the ground. Disengage auxiliary hydraulics. Stop Engine.
Engage parking brake. Remove the key.
WARNING! Operatingthestandardowrotarycutteronahighowhydraulicsystem
may cause severe injury or death to the operator or bystanders due to the
increasedRPM.DoNOToperatethestandardowrotarycuttersonhighow
hydraulic systems.
WARNING! Lift limiting chain must be properly installed before operation.
WARNING! AVOID STALLING ROTARY CUTTER. During operation, continuous blade
rotation is required to prevent overheating of the hydraulic system. To
monitor the blade rotation, there is a window in the motor cover shield so
the operator can monitor the blade rotation indicator disk. This disk should
always be rotating during operation to prevent overheating of the hydraulic
system.