What does 7 flashes mean on Bradford White RG240T6X?
If your Bradford White Water Heater flashes seven times with a three-second pause, it indicates a gas valve electronic fault. First, verify that the control is not wet or physically damaged. Then, turn the set point knob to the 'OFF' position, then to the 'PILOT' position, and light the pilot. If the seven-flash error continues, the gas valve may need to be replaced.
What to do if my Bradford White RG240T6X flashes 5 times?
If your Bradford White Water Heater displays five flashes with a three-second pause, it indicates a temperature sensor fault. This could be due to damage to the temperature wire or the temperature sensor resistance being out of range. Try turning the set point knob to the 'OFF' position, then to the 'PILOT' position, and light the pilot. If the issue persists, the temperature sensor may need replacement. If replacing the temperature sensor doesn't solve the problem, verify the control is not wet or physically damaged. If the five-flash error continues, consider replacing the gas valve.
Why does my Bradford White RG240T6X Water Heater flash 4 times?
If your Bradford White Water Heater shows four flashes with a three-second pause, it means there's an excessive tank temperature issue. This could be due to a temperature sensor being out of calibration or a faulty gas valve. The system requires a reset.
Why is my Bradford White Water Heater flashing 3 times?
If your Bradford White Water Heater is flashing three times with a three-second pause, it suggests insufficient water heating. This could be due to a temperature sensor out of calibration or a possible short. Check the system settings and note that the system will reset.
What does 8 flashes mean on my Bradford White RG240T6X Water Heater?
If your Bradford White Water Heater is flashing eight times with a three-second pause, it indicates a false pilot flame. This can occur if the pilot valve is stuck in the open position. Try turning the set point knob to the 'OFF' position, then to the 'PILOT' position, and light the pilot. If the eight-flash error persists, consider replacing the gas valve.
What does 6 flashes mean on Bradford White RG240T6X Water Heater?
If your Bradford White Water Heater is flashing six times with a three-second pause, it means a water leak has been detected by the accessory module (on some models).
What does 2 flashes mean on Bradford White Water Heater?
If your Bradford White Water Heater flashes twice with a three-second pause, it indicates a weak pilot flame. This might be due to an unstable pilot or a blocked/restricted pilot tube. The system will automatically reset once a sufficient pilot flame is detected.
Critical warnings about fire, explosion, and injury from improper use.
Guidelines for handling flammable vapors and system safety features.
Guidance on selecting an appropriate and safe installation location.
Detailed steps for safely lighting and shutting down the appliance.
Detailed steps for safely lighting and shutting down the appliance.
General| Brand | Bradford White |
|---|---|
| Model | RG240T6X |
| Category | Water Heater |
| Language | English |
To Next Page