BrainQ RSC/2 - Creating and Managing Time Programs; Individual Time Program Generation; Reference to Standard Program P1

GB
Heating
circuit
Push for approx. 3 seconds
Programming of operating times
Page GB-14
2200..55
1155::3300
WWEE 2255.. JJUUNN..;;0033
°C
TTIIMMEEPPRROOGGRRAAMMSS
HHCC
TTIIMMEEPPRROOGGRRAAMMSS
TTIIMMEEPPRROOGGRRAAMMSS
Enter timeprogram level
Standard display
DDHHWW
select
accept
Example: Direct circuit
accept
With this mode of operation individual timeprograms can be generated for heating and hot-water
mode. For this purpose the factory preset standard program (P1) is called up after selecting the res-
pective circuit and can be individually overwritten.
For the programming of timeprograms a maximum of three heating cycles with a switch-on and
switch-off time is available for each weekday. Apart from that a desired room temperature or dome-
stic hot water temperature can be set for each heating or domestic hot water cycle.
3sec
if necessary select program, if enabled (see page 23)
8A520900_GB.qxp 11.11.2004 14:41 Seite 14