GB
Page GB-23
Entry:
SSYYSSTT
SSYYSSTTEEMM
mm
NNLL
SSYYSSTT
PPAARRAAMMEETTEERR 0011
mm
PP11
PPAARRAAMMEETTEERR 0022
Parameter 1 - language selection
Setting range: NL = DUTCH GB = ENGLISH
F = FRENCH I = ITALIAN
Factory setting: NL
Parameter 2 - Timeprogram
Setting range: P1, P1-P3
Factory setting: P1
SSYYSSTT
SYSTEM
All information appearing on the display is available in the lan-
guages Dutch, English, French and Italian. The selected langu-
age can be selected and activated according to the above
assignment.
Application: Use of the instrument in the corresponding lan-
guage area
This parameter specifies the number of the cleared timepro-
grams. With setting P1 only one timeprogram is available, with
setvalue P1-P3 all three programs are cleared.
Application: Frequently changing timeprograms, e.g. shift
work with different working times
Note: Only accessible with code 1234.
Contents: General limitation parameters and functions, which
refer to the respective heating system.
Entry: see level synoptic page 12-13
Exit: Button
¢¢
or automatically after approx.
60 seconds.
Change: Accept selected flashing parameter by pressing
the rotary pushbutton. Then change the parame-
ter value and accept by pressing the rotary push
button again.
next parameter
next parameter
To Next Page
Loading...
