7
Knifonium
Plugin Manual
Osc MIXER
1
VCO 1
Sets the VCO 1 output level.
The mixer stage is tube-based and depending on the overall input level(s), it
can slightly saturate or even distort the signal. We modelled this interactive
behaviour according to the hardware unit, thus giving it a non-linear type
character.
Tip: Dial back VCO1, VCO2, Noise, RingMod to get an overall cleaner sound
whilst raising level via the Master Vol. output.
2
VCO 2
Sets the VCO 2 output level.
3
VCO 2 Mod Source
Switches the modulation source for the VCO 2 output level. Mod source can be
Mod Wheel, Aftertouch or disengaged (Off).
4
Noise
Sets the noise generator output level. An Excellent tool for percussive sounds,
layering etc.
1 2 4
3
To Next Page