Need help?Do you have a question about the Branson TA00037774A and is the answer not in the manual?
General| Brand | Branson |
|---|---|
| Model | TA00037774A |
| Category | Tractor Accessories |
| Language | English |
Remove fender, seat plate, and back plate. Loosen locking nut on the 90° adapter, but do not remove the hose.
Install the two studs as shown, ensuring O-rings on the pressure regulating block are not damaged.
Stack valve body sections with spool actuators facing front and rear, install pressure regulating block, and tighten locking nut.
Install the brackets securely as shown, ensuring correct placement on the rock shaft housing.
Attach valve control linkage to handle assembly using cotter pins and flat washers, with the cut-out link on the upper lever.
Connect valve linkage to spool actuators, ensuring the flat side of the spool actuator faces upwards.
Install the lever assembly onto the bracket assembly, using quick couplers and dust plugs, with long adapters on side or bottom ports.
Re-install fender, seat plate, and back plate. Slide knobs onto levers sticking through the seat plate slots.
To Next Page