6
Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Foil release button
5 Long hair trimmer
6 Switch
7 Charging light (green)
8 Pilot light
9 Shaver socket
10 Special cord set
Charging the shaver
•
First charging: Using the special cord set, plug the shaver
into an electrical outlet with the switch on position «0» and
charge it for at least 4 hours (plug might get warm).
•
Once the shaver is completely charged, shave without
the cord until fully discharged. Then recharge to full
capacity again (subsequent charges will take about
1 hour).
•
A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth.
However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
•
Best environmental temperature range for charging
is 60°F to 95°F / 15°C to 35°C.
Indicator lights
•
The pilot light shows that the shaver is plugged into the
outlet properly.
+35°C
+15°C
210
7570
5494308_S 4-26 Seite 6 Mittwoch, 21. September 2005 3:28 15
To Next Page
Loading...
