To Next PageTo Next Page
Need help?Do you have a question about the Braun A5S1 Series and is the answer not in the manual?
Lists all figures and their corresponding page numbers within the manual.
Provides definitions for all abbreviations used throughout the document.
Details the intended use, operating conditions, and sensor types for specific applications.
Explains the correct procedure for sensor installation, including alignment and air gap.
Specifies the pin numbers and wire colors for connecting the sensor.
Illustrates the pin configuration of the sensor's connector.
Covers signal frequency, transmission distance, cable requirements, and shielding.
Explains how the sensor indicates the direction of rotation based on output signal levels.
Describes the two phase-shifted signals used for speed and direction detection.
Details the characteristics of the sensor's output signal under varying load conditions.
Explains the systematic way to construct sensor model numbers based on specifications.
Directs users to the safety datasheet for comprehensive safety information.
Lists the various certifications and approvals relevant to the sensor series.
Specifies technical parameters and data relevant for operation in hazardous environments.
Details the ATEX certification status for the sensor's input circuit.
Lists all certificates and approvals pertaining to explosive atmosphere safety.
Provides essential general safety guidelines for installing and operating the sensors.
Outlines the sensor's compliance with Electromagnetic Compatibility (EMC) regulations.
Warns about potential metallic abrasion and necessary precautions during operation.
Covers critical safety considerations and procedures for sensor installation.
Outlines crucial safety precautions to be observed during the sensor's operational phase.
Lists the specific standards and directives the sensor complies with.
Specifies the required supply voltage and conditions for safe operation in hazardous zones.
Describes the output signal type, level, and protection features.
Defines the operational speed limits and maximum signal frequencies for sensor models.
Provides information on cable types, impedance, and capacitance for signal transmission.
Details the protective measures implemented, such as IP rating and housing material.
Explains the various available connection methods, including connectors and cables.
Lists the temperature limits for safe sensor operation based on certification.
Information on the expected lifespan and replacement recommendations for the sensors.
General| Brand | Braun |
|---|---|
| Model | A5S1 Series |
| Category | Accessories |
| Language | English |
