9
4. Remaining shaving time / Shaver must be charged.
5. Time left in the cleaning process.
6. Replace shaving foil and cutter block. To help obtain
a new shaver foil and cutter block at your dealer or
Braun Service Center, the display shows the part
No. 8000. To reset the display, push the info key (17).
We recommend to follow the display’s suggestion,
i.e. replace foil and cutter block every 18 months.
Change both parts at the same time for a closer
shave with less skin irritation.
7. System has initiated automatic battery maintenance
(it is fully discharging and then recharging the
batteries).
8. Environment temperature not suited for charging.
Allow the shaver to remain for some time at room
temperature for optimal charging conditions.
Best environmental temperature range for charging
is 15 °C to 35 °C.
9. Intensive cleaning needed – return to the
Clean&Charge station as soon as possible.
To reset the display, push the info key (17).
10. Info key, press once: duration of last shave.
Press again: total number of shaves (cannot be reset).
Press again: key part number for shaver foil and
cutter block. Hold for 3 seconds: runs a display
demo.
11. No display – shaver is completely discharged.
Accessories
Available at your dealer or Braun Service Centres:
• Shaver foil and cutter block
No. 8000
• Cleaning cartridge Clean&Charge
CCR
5643451_S4_102 Seite 9 Montag, 8. September 2003 11:48 11
To Next Page
Loading...
Need help?
General
