To Next PageTo Next PageHow to get rid of the unpleasant smell from Braun 7 series Electric Shaver head?
To address an unpleasant smell from the shaver head of your Braun Electric Shaver, ensure that when cleaning the shaver head with water, you only use hot water and occasionally some liquid soap (without abrasive substances). Also, remove the Foil & Cutter cassette to allow it to dry properly.
Why has my Braun 7 series shaving performance dropped significantly?
If the shaving performance of your Braun Electric Shaver has dropped significantly, it could be due to several reasons. First, the foil and cutter might be worn and need replacement. Second, check if the personal setting of shaving performance has been changed; for a thorough and fast shave, the green (intensive) setting is recommended. Third, the shaving system might be clogged. To resolve this, soak the Foil & Cutter cassette in hot water with a drop of dish liquid, then rinse and tap it out. Once dry, apply a drop of light machine oil to the foil.
Why has the battery performance of my Braun 7 series dropped significantly?
If the battery performance of your Braun Electric Shaver has dropped significantly, it could be due to worn foil and cutter requiring more power for each shave, or the shaver head is regularly cleaned with water but not lubricated. To fix this, renew the Foil & Cutter cassette. If you regularly clean the shaver with water, apply a drop of light machine oil on top of the foil once a week for lubrication.
Why is the shaver head damp on my Braun Electric Shaver?
A damp shaver head on your Braun Electric Shaver can happen for a few reasons: either the drying time after automatic cleaning was too short, so clean directly after shaving to allow enough time for drying; or the drain of the Clean&Renew station is clogged, so clean the drain with a wooden toothpick and regularly wipe the tub clean. It could also be that the cleaning cartridge has been used for quite a while, in which case the ethanol/isopropanol proportion has decreased while the oil proportion has increased, so remove residue with a cloth.
Why does my Braun Rechargeable shaver turn off with a fully charged battery?
Your Braun Rechargeable shaver might be turning off even with a full battery because the foil and cutter are worn. This requires more power than the motor can deliver, causing the appliance to shut down. Renew the Foil & Cutter cassette and regularly oil the shaving system, especially when cleaning with water only.
Why does my Braun 7 series turn off with a full battery?
If your Braun Electric Shaver turns off even with a fully charged battery, it's likely due to worn foil and cutter, demanding more power than the motor can provide. Replace the Foil & Cutter cassette and regularly oil the shaving system, especially if you clean it with water alone.
What to do if my Braun Rechargeable shaver turns off with a fully charged battery?
If your Braun Rechargeable shaver turns off even with a fully charged battery, it could be due to worn foil and cutter requiring more power than the motor can provide. You can fix this by renewing the Foil & Cutter cassette and regularly oiling the shaving system, especially after cleaning it with water.
Why is my Braun Rechargeable shaver head damp?
A damp shaver head on your Braun Rechargeable shaver can be due to a few reasons: either the drying time after automatic cleaning was too short, the drain of the Clean&Renew station is clogged, or the cleaning cartridge has been used for too long. To address this, clean the shaver directly after shaving to allow sufficient drying time. Clean the drain with a wooden toothpick and regularly wipe the tub clean. If the cleaning cartridge has been used for a while, the ethanol/isopropanol proportion has decreased while the oil proportion has increased; remove any residue with a cloth.
Why is my Braun Rechargeable shaver consuming cleaning fluid so quickly?
Increased cleaning fluid consumption in your Braun Rechargeable shaver could be due to a clogged drain in the Clean&Renew station. Clean the drain with a wooden toothpick. Also, regularly wipe the tub clean.
Why is the shaver head of my Braun 7 series damp?
A damp shaver head can result from a few issues: 1. The drying time after automatic cleaning might be too short. Try cleaning directly after shaving to allow ample drying time. 2. The Clean&Renew station's drain could be clogged. Clean it with a wooden toothpick and regularly wipe the tub clean. 3. The cleaning cartridge might have been used for too long, decreasing the ethanol/isopropanol proportion while increasing the oil proportion. Remove any residue with a cloth.
General| Sonic Technology | Yes |
|---|---|
| Wet & Dry | Yes |
| Charging Time | 1 Hour |
| Running Time | 50 minutes |
| Travel Lock | Yes |
| Precision Trimmer | Yes |
| Waterproof | Yes |
| Series | 7 |
| Shaver Type | Foil Shaver |
| Battery Type | Li-Ion |
| Quick Charge | 5 minutes for one shave |
| Display | Yes |
| Cleaning Station | Clean & Charge Station (depending on the model) |
Step-by-step guide for setting up the cleaning station and inserting the cleaning cartridge.
Instructions on operating the shaver, including usage tips and personalization settings.
Instructions for performing the automatic cleaning cycle using the Clean&Renew station.
Addresses common shaver problems like unpleasant smell, battery issues, and performance drops.
Covers problems with the cleaning station's operation, fluid consumption, and starting issues.
