Braun 7 series - User Manual

Other manuals for Braun 7 series

User Manual7 pages

Cleaning Instructions8 pages

Instructions35 pages

Instruction Manual101 pages

Questions and Answers:

H
harttammyAug 28, 2025
Why is the shaver head of my Braun 7 series damp?
- A
  Anne FernandezAug 28, 2025
  A damp shaver head can result from a few issues: 1. The drying time after automatic cleaning might be too short. Try cleaning directly after shaving to allow ample drying time. 2. The Clean&Renew station's drain could be clogged. Clean it with a wooden toothpick and regularly wipe the tub clean. 3. The cleaning cartridge might have been used for too long, decreasing the ethanol/isopropanol proportion while increasing the oil proportion. Remove any residue with a cloth.
H
Heather ThompsonSep 23, 2025
Why does my Braun Rechargeable shaver turn off with a fully charged battery?
- S
  Steve YoungSep 23, 2025
  Your Braun Rechargeable shaver might be turning off even with a full battery because the foil and cutter are worn. This requires more power than the motor can deliver, causing the appliance to shut down. Renew the Foil & Cutter cassette and regularly oil the shaving system, especially when cleaning with water only.
J
jonesmarissaAug 29, 2025
What to do if the Braun 7 series Electric Shaver head is damp?
- B
  beckdeniseAug 29, 2025
  If the shaver head of your Braun Electric Shaver is damp, consider these possibilities: 1. Insufficient drying time after automatic cleaning. 2. A clogged drain in the Clean&Renew station. 3. Extended use of the cleaning cartridge. Clean the shaver directly after shaving to allow ample drying time. Clean the drain with a wooden toothpick and regularly wipe the tub clean. If the cleaning cartridge has been used for a while, the ethanol/isopropanol proportion has decreased while the oil proportion has increased; remove residue with a cloth.
E
Erica SwansonAug 30, 2025
What to do if cleaning doesn't start on my Braun 7 series Electric Shaver?
- D
  Danny GainesAug 30, 2025
  If the cleaning cycle doesn't start when you press the start button on your Braun Electric Shaver's Clean&Renew station, check the following: 1. Ensure the shaver is properly placed in the station, with the contacts aligned. 2. Verify the cleaning cartridge has sufficient fluid (if the display lights red, it needs replacing). 3. Confirm the appliance is not in standby mode; press the start button again.
R
Rodney SanchezAug 30, 2025
Why is there increased consumption of cleaning fluid in my Braun Electric Shaver?
- K
  Kelsey NealAug 30, 2025
  Increased consumption of cleaning fluid is often due to a clogged drain in the Clean&Renew station. Clean the drain with a wooden toothpick and regularly wipe the tub clean.
O
olivia33Aug 31, 2025
What to do if shaving system of my Braun 7 series is still wet after cleaning?
- J
  Joseph GoodwinAug 31, 2025
  If the shaving system of your Braun Electric Shaver remains wet after the cleaning program finishes, it could be due to these reasons: 1. The drain of the Clean&Renew station might be clogged. Clean it with a wooden toothpick and regularly wipe the tub clean. 2. The cleaning cartridge may have been in use for too long, decreasing the ethanol proportion and increasing the oil proportion. Remove residue with a cloth.
K
kelseydavidsonSep 18, 2025
What to do if cleaning doesn't start on my Braun Rechargeable shaver?
- F
  Francisco VincentSep 18, 2025
  If the cleaning process doesn't start when you press the start button on your Braun Rechargeable shaver's Clean&Renew station: 1. Ensure the shaver is properly placed in the Clean&Renew station, aligning the contacts. 2. Check if the cleaning cartridge has enough cleaning fluid (if the display lights red, insert a new cartridge). 3. If the appliance is in standby mode, press the start button again.
L
Lindsay BushSep 14, 2025
Why is there increased consumption of cleaning fluid with my Braun 7 series?
- S
  sandra68Sep 14, 2025
  Increased consumption of cleaning fluid with your Braun Electric Shaver often means the drain of the Clean&Charge Station is clogged. Clean the drain with a wooden toothpick and regularly wipe the tub clean.
R
Roger ReedSep 1, 2025
What to do if my Braun Rechargeable shaver turns off with a fully charged battery?
- G
  gpittmanSep 1, 2025
  If your Braun Rechargeable shaver turns off even with a fully charged battery, it could be due to worn foil and cutter requiring more power than the motor can provide. You can fix this by renewing the Foil & Cutter cassette and regularly oiling the shaving system, especially after cleaning it with water.
S
snguyenSep 2, 2025
What to do if cleaning doesn't start when pressing the start button on my Braun Rechargeable shaver?
- M
  Michael CurtisSep 2, 2025
  If the cleaning cycle doesn't start when you press the start button on your Braun Rechargeable shaver, consider the following: 1. Ensure the shaver is correctly placed in the Clean&Renew station, with the shaver's contacts aligned with the station's contacts. 2. Check if the cleaning cartridge has sufficient cleaning fluid; a red light indicates it needs replacement. Insert a new cleaning cartridge if necessary. 3. Verify the appliance isn't in standby mode. Press the start button again to initiate cleaning.

Braun 7 series Specifications

General

Sonic Technology	Yes
Wet & Dry	Yes
Charging Time	1 Hour
Running Time	50 minutes
Travel Lock	Yes
Precision Trimmer	Yes
Waterproof	Yes
Series	7
Shaver Type	Foil Shaver
Battery Type	Li-Ion
Quick Charge	5 minutes for one shave
Display	Yes
Cleaning Station	Clean & Charge Station (depending on the model)