Braun BC07-DCF Quick Setup Guide

BC07-DCF
Alarm clock
(Radio controlled)
Quick set-up guide
Battery installation
1.Insert 1xAA (1.5V) battery observing the
correct polarity, as shown on the diagram.
2. Replace battery cover.
Only use new alkaline batteries from a
reputable brand.
Radio controlled clock operation
We strongly recommend you start your clock
at night. Once the battery is installed properly,
the clock automatically sets itself to 12 o’clock
and then begins receiving the signal. Once it
has received the DCF signal and processed
it accordingly (which takes 3 to maximum 12
minutes), the clock will automatically display
the correct time.
Alarm / snooze function
When the alarm time is reached, the alarm will sound
for a maximum of 2 minutes if the ALARM is ON and
the SNOOZE / LIGHT button is not pressed.
Illumination
1. To be able to read the face of your alarm clock
when it is dark, briefly press on the top of the alarm
clock to activate the SNOOZE/LIGHT button at the
bottom.
2. The illumination function is activated for 5
seconds.
Alarm setting
To set the alarm follow below procedures:
1. Press the ALARM SET knob located at the back of
the clock, the rotating switch will pull outwards.
2. Turn the knob in the direction of the arrow
until desired alarm time is shown, only turn in
the direction of the arrow to avoid damaging the
movement.
3. Press the ALARM TAB located on the top to
activate the alarm, green bar will be shown at the
front.
4. Press back the ALARM SET knob located at the
back of the clock.
+
5 sec5 min
Zzz
Braun helpline
Should you have a problem with your
product, please check your local service
centre at:
www.braun-clocks.com
www.braun-watches.com
Certain trademarks used under license from the
Procter & Gamble Company or its affiliates.
For detailed information refer to
the full user manual available at
www.braun-clocks.com/pages/warranty
or scan this code:

Braun BC07-DCF Specifications

General

Brand	Braun
Model	BC07-DCF
Category	Alarm Clock
Language	English