Braun BC10-DCF Quick Setup Guide

Braun helpline
Should you have a problem with your
product, please check your local
service centre at:
www.braun-clocks.com
www.braun-watches.com
For detailed information refer to
the full user manual available at
www.braun-clocks.com/pages/warranty
or scan this code:
3
5
4
2
6
1
Battery installation
1. Remove the battery door.
2. Insert 1x AA size new battery as indicated in the battery
compartment ( ) and press the RESET key ( ) to reset the
clock. The display will turn on after a few seconds.
3. Close the battery door.
Only use new alkaline batteries from a reputable brand.
Radio controlled clock operation
This Braun clock is automatically set and controlled by DCF
radio signal for Central European time zone. This covers
most of Central and Western Europe, including Germany,
France, Netherlands, Belgium, Denmark, Switzerland,
Northern Italy, etc. Not suitable for UK or Ireland.
The clock updates the signal during the night. Therefore,
we recommend starting your clock at night and to avoid
placing it near interfering sources such as TV sets,
Microwaves, computers, and away from metal surfaces.
Once the battery is installed properly, the clock begins
receiving the DCF signal. Once it has received the signal
and processed it accordingly (which takes 3 to maximum
12 minutes), the clock will automatically display the correct
time.
Setting the time
1. Slide the TIME SETTING / NEUTRAL / ALARM SETTING
switch ( ) to the TIME SETTING position.
2. Press the ‘+’ or ‘-’ key ( ) to set the desired value.
3. Slide the TIME SETTING / NEUTRAL / ALARM SETTING
switch to the NEUTRAL position to return the normal
display and save the settings.
Setting the alarm
1. Slide the TIME SETTING / NEUTRAL / ALARM SETTING
switch ( ) to the ALARM SETTING position.
2. Press the ‘+’ or ‘-’ key ( ) to set the desired value.
3. Slide the TIME SETTING / NEUTRAL / ALARM SETTING
switch to the NEUTRAL position to return the normal
display and save the settings.
Using the alarm function
1. Enable the alarm by pushing the ALARM ON / OFF slider
( ) up (so the green indicator is visible).
2. To disable the alarm and snooze function, push the
ALARM ON / OFF slider down.
Using the snooze function
Tap the SNOOZE touch button ( ) to stop the alarm and
activate the snooze function. When the snooze function is
activated, the alarm will automatically start again after 5
minutes. The snooze function will not stop unless the
ALARM ON / OFF SLIDER is pushed down
2 3
1
1
5
5
4
6
BC10-DCF
Alarm clock
(Radio controlled)
Quick set-up guide

Braun BC10-DCF Specifications

General

Brand	Braun
Model	BC10-DCF
Category	Alarm Clock
Language	English