3202 - 12
BINC Rev: 4/97 Service Documentation
Service Information
BAG Rev: 2/97 3202
Attention must be paid to the reassembling position of the motor and to the cable
connection (+/-), see sketch 3.
Tension of the toothed belt: Slightly loosen the motor securing screws and displace the
motor (18) on the carrier. If the toothed belt is correctly tensioned, the motor securing
screws (25) will be tied. Please refer to sketch 4 for the tension value of the toothed
belt.
The both washers (22) must be attached to the shafts. The O-rings (15) must be
inserted into the housing.
Attach all dampers (23) for the carrier.
Insert the completely reassembled carrier into the housing (9).
Connect the leads to the switch-PCB (36), see sketch 3.
Insert the switch-PCB into the guides of the base plate and the switch cams (37), see
sketch 6.
Attach the base (33) and the rubber feet (34).
Place the supporting plate underneath the corresponding coupling shaft. Then, press
the coupling onto the shaft by slightly tapping against the embossing spike. The axial
free space of the coupling shafts must be 0.4 mm - 0.6 mm, see sketch 5 (symbolic
illustration). A smaller or larger axial free space may cause a defect of the appliance.
Insert the setting knob (10), and make sure that the potentiometer for the setting knob
axis is placed in the correct position.
Insert the spring (14) into the housing front.
Assemble the pressure spring (13), the button (12) and the switch knob (11), see
sketch 6.
Connect the leads to the switching-PCB (5) and insert the switching-PCB into the
housing upper part.
Insert the lever (4) and the leg spring (3), see sketch 7 (symbolic illustration).
Attach the cover (1) to the housing upper part until it snaps in.
To Next Page
Loading...
