13 Labels and Symbols
The
device is marked with the following symbols:
[I)
Type
BF
Applied
Part
(g]
Class
II
equipment
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to
part
15
of
the
FCC
Rules. These limits
are designed to provide reasonable protection against harmful interference
in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance
with
the
instructions, may cause harmful interference
to
radio communications.
~
However, there is no guarantee that interference will
not
occur in a particular
installation. If this equipment does cause harmful interference
to
radio or
television reception, which can be determined
by
turning the equipment off
and
on, the user is encouraged to
try
to
correct
the
interference by one or more of
the following measures:
- Reorient
or
relocate the receiving antenna.
- Increase the separation between the
equipment
and receiver.
- Connect
the
equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult
the
dealer or
an
experienced radio/TV technician for help.
CID
Follow instructions for use
K
WEEE
waste disposal mark
of
the European Union
-
(€
Conformity mark
of
the European Union
[f]
Keep Dry
24V = 1.25A
~
Direct current Connection polarity
=--Gil-c
Only use with Power Supply 6037
Ceus
NATL Certification marking
14 Technical specifications
Gillet:t~ V~nus Silk-expert is a filtered broadband Intense Pulsed Light system with
the
following technical
spec1f1cat1ons:
Repetition rate:
Max optical output:
Pulse length
Power line input:
Operating temperature:
Optimum operating temperature:
14
manually pulsed e~ery 2-
3
seconds (depending on treatment setting),
continuous operation
4J/cm
2
2.6
msec
FWHM
100 • 240V~, 50/60Hz, 0.8A
s·c -
4o·c;
41
·F.
104·F
1 s·c -
3o
·c ; 59"F - 86"F
To Next Page
Loading...
