Why is my Braun Iron ready, but there's no steam coming out?
If your Braun Iron is ready but not emitting steam, it could be due to the end-of-water alarm being reset without refilling the water. Refill the water tank and press the steam button several times for 1 minute until the pump loads water inside the system. If that doesn't work, turn off the appliance and wait until it has cooled down.
Why is my Braun IS 3044/1 WH Iron dripping water from the soleplate?
If your Braun Iron is dripping water, it's likely due to water condensation inside the tubes, especially if the steam function is new or hasn't been used recently. To fix this, press the steam button several times away from the ironing board to eliminate cold water from the steam circuit.
What to do if steam comes out from the cleaning valve of my Braun Iron?
If steam is escaping from the cleaning valve of your Braun Iron, it could be that the valve isn't tightened correctly. Turn off the appliance and tighten the cleaning valve properly, but avoid overtightening it. If the issue continues, the cleaning valve gasket may be damaged, in which case you should turn off the appliance immediately and contact an authorized Braun Customer Service.
Why is brown fluid leaking from my Braun IS 3044/1 WH's soleplate?
If brown fluid leaks from the soleplate of your Braun Iron, it's because chemical water softeners or additives have been poured into the water tank boiler. Never pour such products into the water tank. Clean the soleplate with a damp cloth and rinse the boiler.
What to do if all LEDs are flashing on my Braun Iron?
If all the LEDs on your Braun Iron are flashing, unplug the system, plug it in again, and press the On/Off button. If the problem persists, turn off the appliance immediately and contact an authorized Braun Customer Service.
Why does my Braun Iron smoke when I turn it on for the first time?
It's normal for a new Braun Iron to emit smoke or smell upon first use. This is due to sealers or lubricants evaporating as the iron heats up. It should stop after a few uses. If the smoke/smell persists after turning off the appliance, contact an authorized Braun Customer Service.
Why is steam coming out under the base unit of my Braun IS 3044/1 WH Iron?
Steam coming out from under the base unit of your Braun Iron indicates that the “max” pressure safety system has opened. Turn the appliance off immediately and contact an authorised Braun Customer Service.
Why does my Braun IS 3044/1 WH Iron make noise and vibrate intermittently?
An intermittent noise and vibration in your Braun Iron usually means water is being pumped into the boiler, which is normal and requires no action. Alternatively, the water tank could be empty. Refill the water tank and press the reset button.
General| Type | Steam Iron |
|---|---|
| Power | 2400 W |
| Steam Output | 40 g/min |
| Anti-Drip System | Yes |
| Vertical Steam | Yes |
| Auto Shut-off | Yes |
| Self-cleaning | Yes |
| Color | White |
| Soleplate | Ceramic |
To Next Page