12
Dip the puree accessory into the ingredi-
ents and switch on the appliance.
Using a gentle up and down motion,
move the puree accessory through the
ingredients until the desired texture is
achieved.
Release the Smartspeed switch and en-
sure the puree accessory has completely
stopped turning before removing it from
the food.
After use, unplug the appliance. Remove
the paddle (7c) by turning clockwise.
Press the EasyClick Plus release buttons
to detach the puree accessory from the
motor part. Separate the gearbox from
the shaft by turning counterclockwise.
Caution
Never use the puree accessory in a
saucepan over direct heat.
Always remove the saucepan from the
heat and allow to cool slightly.
Sit the saucepan or bowl on a stable,
flat surface, and support it with your free
hand.
Do not tap the puree accessory on the
side of the cooking vessel during or after
use. Use a spatula to scrape excess food
away.
For best results when mashing never fill a
saucepan or bowl more than half full with
food.
Do not process more than one batch
without interruption.
Let the appliance cool down for 4 minutes
before you continue processing.
Recipe Example: Mashed Potatoes
2.2 lbs / 1 kg cooked potatoes
7 fl. oz / 200 ml warm milk
Place the potatoes in a bowl and mash for
30 seconds (3/4 way on the Smartspeed
switch).
Add the milk. Resume mashing for anoth-
er 30 seconds.
Chopper Accessory (C)
The choppers (8/9/10) are perfectly suited
for chopping hard cheese, onions, herbs,
garlic, vegetables, bread, crackers and
nuts.
Use the «hc» chopper (8) for fine results.
Maximum operation time for the «hc»
chopper: 1 minute for large amounts of
wet ingredients, 30 seconds for dry or
hard ingredients or amounts < 4 oz / 100g.
Immediately stop processing when motor
speed decreases and/or strong vibrations
occur.
Use the «ca» chopper (9) for larger quanti-
ties and for hard foods.
Refer to the Processing Guide C for maxi-
mum quantities and recommended speeds.
Before Use
Pre-cut foods into small pieces for easier
chopping.
Remove any bones, tendons and gristle
from meat to help prevent damage to the
blades.
Make sure the anti-slip rubber ring
(8d/9d) is attached to the bottom of the
chopper bowl.
Assembly and Operation
Carefully remove the plastic cover from
the blade.
The blades (8b/9b) are very sharp! Al-
ways hold it by the upper plastic part and
handle it carefully.
Place the blade on the center pin of the
chopper bowl (8c/9c). Press it down and
give it a turn so that it locks into place.
Fill the chopper with food and put on the
lid (8a/9a).
Align the chopper with the motor part (2)
and click together.
To operate the chopper, switch on the
appliance. During processing, hold the
motor part with one hand and the chop-
per bowl with the other.
Always chop harder foods (e.g. parme-
san cheese) at full speed.
5722113784_HB701-MQ7025-MQ7077x_USCA__V08.indd 12 04.11.19 10:24
To Next Page
Loading...
Need help?
General
