10
Select mode
Setting date and time
First turn off the appliance. Push the select button (D) for
longer than 3 seconds to enter the select mode. Wait for
a confirmation beep. The day position of the displayed
date starts flashing. Using the memory button (E), you
can adjust the date. Press the select button again to
make the month position flash, adjust it using the
memory button. Press the select button again and
proceed the same way to adjust the time (hour/minute).
After having changed date and time, press the on/off
button (C) to confirm. The device will then turn off.
Deactivating the positioning system (A)
Should you wish to deactivate the positioning system
(e.g. because you want to measure while lying down),
proceed as follows:
Turn off the product. Push the select button (D) for longer
than 3 seconds and wait for the confirmation beep.
The display shows the date and time settings. Then
repeatedly press the select button until the positioning
system symbol ( ) will be displayed next to a flashing
«ON».
Press one side of the memory button to change the
setting from
«ON» (positioning system activated) to
«OFF» (positioning system deactivated).
To confirm
the change of setting, press the on/off button
(C).
Please note:
Unless you confirm a modified setting by pressing the
on/off button, the appliance will turn off automatically
after 2 minutes without adapting the modified setting.
6084401_BP3550/60_S4-80 Seite 10 Mittwoch, 20. Dezember 2006 1:56 13
To Next Page
Loading...
Need help?
General
