Braun TrueScan BPW4100 - Page 9

9
Turning off
Press the on/o button to turn the product o, otherwise the
product will turn o automatically after 2 minutes.
Memory Mode
Your blood pressure monitor can store the readings of 80 (2x40)
measurements. Storing is done automatically after each com-
pleted measurement. The memory is non-volatile. This means
that you will not lose stored data when changing batteries. Once
the memory is full, the oldest values will be overwritten.
How to review the memory
• Make sure the product is in power o mode.
• Press the Memory/Average Function button. The LCD will
display the past 7 days average of blood pressure rst.
• Press the Memory/Average Function button again and the lat-
est reading will display.
• Press it again and the next reading will display.
Average Function: 7 Day Average
• Press the Memory/Average Function button once, and the “7
Day Average” result will show on LCD.
• Make sure the DATE / TIME is correct when taking a measure-
ment, so you will get the correct 7 Day Average result.
• If there is no data in memory within past 7 days, “ ” will show
on LCD.
How to delete the memory data
• Make sure the product is in power o mode.
• Press the Memory/Average Function button for at least 10
seconds.
• LCD will display “del no” as shown.
• Press the Memory/Average Function button again. LCD will
display “del yes”.
• If you are sure all the data of corresponding user can be
deleted, press “power” button, all the corresponding user’s data
will be deleted and the device will shut down.
Note: if you have set “delete yes”, but do not press a button for
2 minutes, the product will shut o automatically, but the cor-