EasyManuals Logo

Braun Wet&Dry 5 Series User Manual

Braun Wet&Dry 5 Series
Go to English
117 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
20
Charging does
not start when
connected to
power socket.
1. Sometimes charging
could start delayed
(e.g. after long stor-
age).
2. Ambient temperature
is out of valid range.
3. Special cord set is not
plugged in properly.
1. Wait a few minutes, if charging will
start automatically.
2. Recommended ambient temperature
for charging is 5 °C to 35 °C.
3. Special cord set needs to snap into
place.
Unpleasant smell
from the shaver
head.
1 Shaver head is cleaned
with water.
2. Cleaning cartridge is in
use for more than
8 weeks.
1. When cleaning the shaver head with
water only use hot water and from time
to time some liquid soap (without
abrasive substances). Remove Foil &
Cutter cassette to let it dry.
2. Change cleaning cartridge at least
every 8 weeks.
Battery perfor-
mance dropped
significantly.
1. Foil and cutter are
worn which requires
more power for each
shave.
2. Shaver head is regu-
larly cleaned with
water but not lubri-
cated.
1. Renew Foil & Cutter cassette.
2. If the shaver is regularly cleaned with
water, apply a drop of light machine oil
on top of the foil once a week for lubri-
cation.
Shaving perfor-
mance dropped
significantly.
1. Foil and cutter are
worn.
2. Shaving system is
clogged.
1. Renew Foil & Cutter cassette.
2. Soak the Foil & Cutter cassette into hot
water with a drop of dish liquid. After-
wards rinse it properly and tap it out.
Once dry apply a drop of light machine
oil on the foil.
Shaver head is
damp.
1. Drying time after auto-
matic cleaning was too
short.
2. Drain of the
Clean&Charge Station
is clogged.
1. Clean directly after shaving to allow
enough time for drying.
2. Clean the drain with a wooden tooth-
pick.
CLEAN&CHARGE STATION
Cleaning does
not start when
pressing the
start button.
1. Shaver is not placed
properly in the
Clean&Charge Station.
2. Cleaning cartridge
contains not enough
cleaning fluid (display
blinks red).
1. Insert shaver into the Clean&Charge
Station and push it to the rear side of
the station (contacts of the shaver need
to align with contacts in the station).
2. Insert new cleaning cartridge. Press
start button again.
91092672_Series_5-2cc_wd_MN_S6-S120.indd 2091092672_Series_5-2cc_wd_MN_S6-S120.indd 20 22.11.16 08:5322.11.16 08:53
CSS APPROVED Effective Date 25Nov2016 GMT - Printed 14Aug2017 Page 20 of 120

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Braun Wet&Dry 5 Series and is the answer not in the manual?

Braun Wet&Dry 5 Series Specifications

General IconGeneral
Wet & DryYes
Charging Time1 hour
Power SourceBattery
Travel LockYes
Automatic Voltage AdaptationYes
Cordless UseYes
Corded UseNo
WaterproofYes
Precision TrimmerYes
Battery TypeLithium-ion
Quick Charge5 minutes for 1 shave
Run Time50 minutes
Shaver TypeFoil

Related product manuals