1
2
3
4
5
6
Message Cause Actions
No diode lit The vehicle's engine is switched on and/
or the door is closed. Power supply
interrupted.
Switch o ignition and check that
fuse(s) and cable(s) are intact. For
further help contact your installer.
1 Red blink Power surge or pinch protection. Turny
stops with small amount of reverse
movement.
Check for obstacle(s) in the way.
Reactive Turny.
2 Red blinks Potentiometer broken or disconnected. Contact your installation engineer.
3 Red blinks Potentiometer/lift motor not moving. Contact your installation engineer.
4 Red blinks Faulty switch for inwards- or outwards-
rotated position. Both aected
simultaneously.
Contact your installation engineer.
5 Red blinks Upper limit position broken, constant
fault.
Contact your installation engineer.
6 Red blinks Max limit for manoeuvring has been
reached, 180 seconds.
Contact your installation engineer.
Alternating Red and Green
LEDs
Upper limit position not aected, and max
outwards-rotation not aected. Turny
cannot be manoeuvred.
Contact your installation engineer.
Hand control error messages
33
To Next Page
Loading...
