Prompt
Don’t push hard into the ear to avoid hurting the eardrum
9.3 The object temperature measurement.
● Take off the Cover of mode conversion, point the thermometer to the object, keep
the probe 3~5mm to the object. Press the measuring key to measure directly,when
the buzzer beeps, the temperature will display on the screen.
● Make sure that the cover of mode conversion is taken off and converted to the Ear
and the object mode.
Prompt
1. All operation should do when power on;
2. All settings will come to default when uninstall the batteries. If need adjust the
settings, please power on and make the new settings..
3. Temperature unit setting must in the state of power off.
4. Memory value can be inquired when power off or any measurement mode
5. The thermometer will be auto off after 30s when idle.
6. Measurement must be carried out when power on and the backlight is off.
7. When the measured temperature value is 38
℃
and above, the backlight is red
and beep while the other value is green. When the measurement vale is between
37.5-37.9
℃
, it is considered low fever, advice to consult the doctor.
9.4 Ambient temperature measurement
1.Take off the mode conversion cover.
To Next Page
Loading...