BRAX X 2000.2 GRAPHIC EDITIONS

Questions and Answers

R
Richard DuranAug 12, 2025
What to do if BRAX Amplifier LEDs light up green but there's no sound?
- N
  Natasha McgeeAug 12, 2025
  If the LEDs on your BRAX Amplifier light up green but you hear no sound, it could be due to a few reasons. First, ensure that all cinch input cables are properly inserted and that your speakers are correctly connected, using screws to fix them in place. Also, a faulty connection between the RCA terminal and the control unit might be the cause. In this case, check the wiring and replace it if necessary.
A
Amber Henderson DVMAug 19, 2025
How to troubleshoot a BRAX Amplifier that cannot be switched on?
- J
  Joseph HamiltonAug 19, 2025
  If your BRAX Amplifier cannot be switched on, there might be an interruption in the 12-volt positive supply lead line. To resolve this, check the power supply fuses and cabling. Another potential cause is that the amplifier isn't correctly connected to the ground or chassis; ensure it's properly connected to the chassis metal. Finally, the power supply to the remote terminal could be interrupted, so check the 12-volt remote output of your control unit (radio/tuner).
R
Russell BoydAug 27, 2025
Why is my BRAX Amplifier picking up interference noise from the engine?
- D
  dennis58Aug 27, 2025
  If you're experiencing interference noise from the engine in your BRAX Amplifier, it could be due to parasitics in the cinch cable. Check the connections, specifically the screen/shield. Alternatively, parasitics in the power supply cabling might be the cause. Consider replacing the cable with a screened BRAX POWER TRAX cable. Another possibility is feedback interference from the chassis to the control unit (radio/tuner). To address this, select an optimum central ground point to serve the entire power supply system of your vehicle, including the control unit (radio/tuner).
P
Patrick WardSep 3, 2025
What to do if only one channel is operating on my BRAX Amplifier?
- B
  bryan00Sep 3, 2025
  If only one channel is operating on your BRAX Amplifier, it could be due to a few reasons. First, check the wiring connections of the affected channel to both the control unit and the speaker, and try swapping the channels around. Another possibility is that the channel has overheated, indicated by a red LED. In this case, turn the amplifier off and allow it to cool before switching it back on. If the LED remains red, consult your dealer. Faulty speaker wiring, such as a short circuit, can also cause this issue. Check the speaker wires and the speakers themselves for short-circuiting, and rectify as necessary. Lastly, one of your speakers might be faulty; if so, replace it with a new one.