7
• Do not repair the unit by yourself. Do not disassemble
the unit by yourself, if any malfunction is detected, and
after it was dropped, unplug the unit and apply to the
service center.
• Transport the kettle in the original package.
• Keep the unit out of reach of children and disabled
persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, DO NOT USE THE UNIT FOR COMMERCIAL
OR LABORATORY PURPOSES.
BEFORE USING THE KETTLE
After unit transportation or storage at low
temperature, it is necessary to keep it for at least
three hours at room temperature.
• Unpack the kettle and remove all packing materials and
advertising stickers.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the kettle for damages, in case of damage do
not plug it into the mains.
• Make sure that the specications of power supply
voltage specied on the lower panel of the unit or
the base correspond to the specications of your
mains. When using the kettle in the mains with 60
Hz frequency, the unit does not need any additional
settings.
• Wipe the outer and inner surface of the ask (1) with a
slightly damp cloth then wipe dry. Do not use abrasives
and coarse scourers for this purpose.
• Place the base (7) on a solid steady at and non-slip
non-metal surface away from heat sources as far as
possible from the edge of the surface.
• Do not place and do not use the kettle in closed space,
for example, in the cupboard or in closed structures —
this can lead to its breakage, cause harm to the user or
damage to his/her property.
• Before connecting the kettle, make sure that there are no
moisture drops on the base (9), the ask (2), the power
cord and the power plug.
Note: on the inner part of the base (9) there is a power cord
storage (10). Select the optimal length of the power cord
laying it in a corresponding way.
• Take the Kettle Handle (8) and remove the Kettle from
the Base (9).
• Press the Lid Opening Key (6) to open the Lid (5).
• Fill the Kettle with water up to the «MAX» mark on the
Water Gauge (3) (Fig. 1)
• Close the Lid (5) and make sure that the Lid (5) is closed
securely.
• Set the Kettle on the Base (9).
• Plug the power cord into an electrical outlet - you will
hear a sound signal, the Digital Indication (11) will show
the water temperature inside the Kettle Jug (2), and
Temperature Measurement Units Indication (12) «°C».
To Next Page
