BRAYER BR1085 - Using the Electric Kettle

8
EN
• Press the On/O󰀨 Power Button (14) « » (Fig. 2); you
will hear a sound signal, and the Digital Indication
(11) will display the water heating temperature. Once
the water temperature reaches 100°C, you will hear a
sound signal, and the heating element of the Kettle will
turn o󰀨.
Note: during water heating in the Jug (2), the color of the
Illumination (1) will change from bright white-blue to red.
• Remove the kettle from the base (9) and carefully pour
out boiled water into a suitable bowl (piс. 3).
• Remember that there is boiling water inside the kettle
ask (2), always hold the kettle only by the handle (8),
do not tilt the kettle sharply, in case of careless use of
the kettle you can get burns by hot water.
• Repeat the water boiling procedure several times.
ATTENTION! To avoid burns by hot steam, do not bend
over the spout (4).
• Hot water resulting from the rst boilings is not
recommended to consume, you may use it for domestic
needs.
USING THE ELECTRIC KETTLE
• Place the kettle (9) on a solid steady at and non-slip
non-metal surface away from heat sources as far as
possible from the edge of the surface.
WATER BOILING
• Take the Kettle Handle (8) and remove the Kettle from
the Base (9).
• Press the Lid Opening Key (6) to open the Lid (5).
• Fill the kettle with water, ensuring it is above the «MIN»
mark but below the maximum «MAX» mark on the Water
Gauge (3) (Fig. 1).
• Close the Lid (5) and set the lled Kettle on the Base (9).
Note: always make sure that no water droplets get on the
contact group of the Base (9).
• Plug the power cord into an electrical outlet - you will
hear a sound signal and the Digital Indication (11) will
show the water temperature inside the Kettle Jug (2)
and the Temperature Measurement Units Indication (12)
«°C».
• Press the On/O󰀨 Power Button (14) «
» (Fig. 2); you
will hear a sound signal, and the Digital Indication (11)
will display the water heating temperature. Once the
water temperature reaches 100°C, you will hear a sound
signal, and the heating element of the Kettle will turn
o󰀨. During water heating in the Jug (2), the color of the
Illumination (1) will change from bright white-blue to red.
• Press the On/O󰀨 Power Button (14) «
» should you
need to turn o󰀨 the kettle during water boiling.
Notes:
- after water reaches boiling, the Digital Indication of
Water Temperature (11) will turn o󰀨 after 30 seconds;
- after boiling water, water droplets may form on the
Base (9) due to steam condensation; this is a normal
occurrence and not covered by the warranty;
- after 3 minute of inactivity, the Kettle will enter standby
mode, you will hear a sound signal and the Kettle will
enter standby mode;