BRAYER BR1085 - Overheating Protection; Cleaning and Maintenance

10
EN
actual water heating temperature inside the Kettle Jug
(2), the Jug Illumination (1) color will change depending
on the water temperature inside the Kettle Jug (2).
• Press the Water Temperature Maintenance Mode
Button « » (15) to activate the water temperature
maintenance mode – the Water Temperature
Maintenance Mode Indication « » (16) will light up.
• Note: the memory function turns on in the water
temperature maintenance mode, if you have removed
the kettle from the Base (9) 10 times and the water
temperature did not go down by 8 degrees below the
set temperature, the water temperature maintenance
function will be active, if the water temperature goes
down by more than 8 degrees from the set temperature,
then the water temperature maintenance function will
turn o󰀨.
• Press the Water Temperature Maintenance Mode
Button « » (15) to deactivate the water temperature
maintenance mode – the Water Temperature
Maintenance Mode Indication « » (16) will turn o󰀨.
OVERHEATING PROTECTION
If you accidentally switched the kettle on, but the water
level appeared to be below the minimal mark, the
automatic thermal switch will be on and the kettle will
switch o󰀨. In this case take the kettle from the base (9)
and let it cool down for 10-15 minutes, then ll the kettle
with water and switch it on, the electric kettle will operate
in normal mode.
CLEANING AND MAINTENANCE
• Before cleaning disconnect the kettle from the mains,
pour out water and let the kettle cool down.
• Wipe the base (9) and the outer surface of the ask (2)
with a slightly damp cloth, and then wipe the base (9)
and the ask (2) dry. Use soft detergents to remove dirt,
do not use metal sponges, abrasive detergents and
solvents.
• Do not immerse the kettle, the kettle stand (9), power
cord and power cord plug in water or any other liquid, do
not wash the kettle in the dishwasher.
DESCALING
• Scale, appearing inside the ask (2), inuences the
water taste and disturbs the heat exchange between
water and the heating element and also creates a risk of
failure of the heating element, the burnout of the heating
element because of large amount of scale in the ask (2)
is not covered by warranty.
• To remove scale, you can use special scale-removing
agents, as well as household ones, for example, vinegar
or citric acid.
• Dissolve 25 g of citric acid in 500 ml of hot water, add
water up to the maximum volume of water in the kettle.
• Pour the resulting solution into the kettle and leave for it
15-30 minutes. If necessary, you can turn on the water
boiling mode.
• Pour out the liquid and rinse the ask (5) several times,
boil water several times.