BRAYER BR4263 - Cleaning and Care

10
EN
• During the vacuum cleaner operation the indicators (8)
light up and electric brush (1).
• When the last indicator (8) starts ashing, switch the
vacuum cleaner o󰀨 and charge the battery (11).
CLEANING AND CARE
Attention!
Provide that the dust bin, the separator (18) and the
HEPA-lter (15) are always clean, because the overall
performance of the vacuum cleaner depends on it.
• It is recommended to clean the dust bin after every
use of the vacuum cleaner. Regularly clean the
separator (18) and the HEPA-lter (15).
• Remove the dust bin from the motor unit of the
vacuum cleaner by pressing the clamp (6).
• To remove garbage and dust place the dust bin (7)
above the trash bin, remove the separator (16) from
the ask (17) (pic. 5), remove garbage and dust from
the ask (17).
Cleaning the dust bin
• Install the separator (16) into the ask (17), install the
dust bin (7) back to its place until the clamp (6) clicking
(pic. 2).
• Remove the separator (16) from the ask (17) (pic. 5).
• Turn the HEPA lter (15) counterclockwise «
» and
remove it from the separator (16) (pic. 6).
• Wash the separator (16) and the HEPA lter (15)
under a warm water jet and dry them (pic. 7, 8). Do
not dry the HEPA lter (15) with a hairdryer or similar
appliances.
• Wash the dust bin ask (17) and dry it.
• Do not wash all removable parts in a dishwashing
machine.
Note: before assembling the dust bin make sure that all
removable parts are clean and dry.
Assembling of the dust bin
• Insert the HEPA lter (15) in the separator (16) and turn
it clockwise «
».
• Install the separator (16) in the ask (12).
• Install the assembled dust bin in the installation place
until the clamp (6) clicking and make sure that the dust
bin is xed properly (pic. 7).
Cleaning the electric brush
• When using the electric brush (2) threads or long hair
etc. can wind up around the rotating brush. Keep the
electric brush (2) clean and clean the round brush as it
becomes dirty.
Cleaning the vacuum cleaner body
• Wipe the vacuum cleaner body with a soft, slightly
damp cloth and then wipe it dry.
• Never immerse the vacuum cleaner body, the electric
brush (2) and the power adapter (19) into water or other
liquids. Make sure that no liquid gets inside the vacuum
cleaner body and the electric brush (2).
• Do not use solvents or abrasives for cleaning the
vacuum cleaner body and the removable parts.