EasyManua.ls Logo

BRAYER BR4263 - Battery Charging; Using the Vacuum Cleaner

BRAYER BR4263
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
EN
BATTERY CHARGING
ATTENTION!
– Use only the battery supplied with the unit. Using a
non-original battery can be dangerous.
– Do not expose Li-ion batteries to impacts and high
temperatures. Do not disassemble the battery to avoid
the electrolyte leakage.
– Do not throw the battery into re.
Avoid the battery terminals circuit, it may cause burns
or re.
– Do not discard the battery with usual household
waste, apply to a specialized center for further recycling.
Before using the unit for the rst time or after a long
period of inactivity, charge the battery.
Install the battery (11). To do this, set the clamp (14)
to the position «
», insert the battery (11) until the
clamp (13) clicking and x the battery (11) by setting
the clamp (14) to the position «
».
Insert the power adapter (18) connection cord jack
(19) into the socket (10).
Connect the power adapter (19) to the mains socket,
the indicator (8) will light up and start ashing. When
the battery (11) is fully charged, all segments of the
indicator (8) will glow constantly.
Full charging of the rechargeable battery takes about
4-5 hours.
After charging the battery disconnect the power
adapter (19) from the mains.
Remove the power adapter (18) connection cord jack
(19) from the socket (10).
Notes:
– charge the battery at the temperature from +5°C to
+35°C.
– if you didn’t use the vacuum cleaner for more than
2-3 months, fully charge the battery before using the
vacuum cleaner.
USING THE VACUUM CLEANER
ATTENTION!
– If the suction power of the vacuum cleaner decreases
rapidly while cleaning, switch it o󰀨 immediately and
check the extension pipe (4) for obstruction. Remove
the obstruction and only then continue cleaning.
– Do not use the vacuum cleaner to collect burning or
smoking cigarettes, cinders, plaster or concrete dust,
our or ashes.
– The vacuum cleaner is not intended for collecting
water or other liquids.
– Do not use the vacuum cleaner in places where
aerosols are used or sprayed, and in proximity to highly
inammable liquids, do not use the vacuum cleaner in
the places where such liquids are stored.

Related product manuals