20
When HOLD mode has not been selected, to release another target, another button
press sequence is required.
Skeet Sequence Voice Mode (SEQ)
In voice release mode (when a microphone is detected) timed Following Pairs are
replaced with a 2 target user selectable Skeet sequence
Release of targets is as follows:
“PULL”–1
st
target is released - BANG - “PULL”–2
nd
target is released.
The Skeet button layout on the TX-101 now becomes:
elease Trapse Trap B
Singles
Press HI to release trap A
Press LO to release trap B
Doubles /Pairs
Press Pair button to release a Double
Skeet Sequence mode can be used with the HOLD mode to repeat the sequence until a
new button sequence is selected.
Skeet Mode – 2 Traps
Voice Release
Use with Instant Release
Skeet Sequence – High Followed By Low
Press SEQ then
Press HI
Skeet Sequence – Low Followed by High
Press SEQ then
Press LO
To Next Page
Loading...