3
2
3
USE WITH BREEO FIRE PIT
1
SET UP ROD
Insert the peg and collar end of the
Rod into the opening on the rim of
your fire pit. Align pegs on the Rod
with the notches on the fire pit,
lower the Rod, ensure the pegs go
down into the opening, and twist
the Rod to secure.
SECURE ROD
Slide the locking collar on the Rod
down, align the tabs, and slide it
into the notches on the fire pit. This
will lock the Rod into place. The
Rod should not spin, and the small
handle of the locking collar should
be facing outward.
ADD OUTPOST GRATE
Loosen the locking thumb screw
(do not remove) and hold the
Outpost Grate horizontally to slide
the sleeve onto the Rod. Secure
the Grate by tightening the locking
thumb screw on the handle. Adjust
the Grate to the desired height and
swivel to your preferred cooking
position. You can then add any
additional Outpost accessories
onto the Rod.
To Next Page
Loading...
