SETTING THE TIME AND DATE
To set the time:
1. Pull the crown out to the 2nd position so that the second hand stops at “0” position.
2. Turn the crown to set the hour and minute hands.
3. After the date has been set, push the crown back to the normal position.
To set the date:
1. Pull the crown out to the 1st position (1).
2. Turn the crown by clockwise to set the date.
* If the date is set between the hours of around 9:00 PM and 1:00 AM, the date may
not change on the following day.
3. After the date has been set, push the crown back to the normal position.
B
3
To Next Page
Loading...
