30
The watch has two pushpieces (A and B) whose action is linked to the function selected. According to the desired
action, the wearer should press the appropriate one
briefly
or
hold it for 2 to 3 seconds.
Pushpiece A: selection of special functions AM/PM, ON/OFF, START/STOP
Crown: backlighting of display by pressing, selection of functions by rotation (position 1);
functions setting or choice of language by rotation (position 2).
Pushpiece B: selection of digits for setting operations (H-MIN-SEC), audible confirmation
signals, alarm tests.
SELECTION AND ADJUSTMENT OF FUNCTIONS
1. Synchronization of analog and digital display
The time indicated by analog display (hands) and that indicated by digital display must be perfectly
synchronized. Should the two displays become desychronized (battery change, shock) the analog display
(hands) must be adjusted to the digital indication as follows:
Select the neutral position then pull crown out to p
osition 2.
Press
pushpiece B briefly: the hours, minutes and seconds (H, MIN and SEC)
of the display each flash in turn.
The respective synchronization of analog H, MIN and SEC (hands) is done by
rotating the crown. N.B. The SEC only move clockwise.
Push the crown back in to position 1.
31
To Next Page
Loading...
