brent C - Models: Ie, Ie-R, and Ie-X

10 brentwheels.com
7. Check that the belt is centered on both
pulleys. NOTE: It is common for the pulleys
to have more grooves than the belts.
8. Place the belt guard back in position
and attach with the three nuts and bolts
removed in step 2.
MAINTENANCE:
STANDARD BELT REPLACEMENT
MODELS:
B, C, CXC,
EX, and #16
continued
MODELS:
IE, IER,
and IEX
1. Turn wheel o and unplug from the power
outlet. Raise the front of the pottery wheel
until the wheel rests on its back legs.
3. Remove the belt guard panel and set aside.
2. Locate the belt guard panel on the bottom
of the wheel. Use a 1/4" socket screwdriver to
remove the four screws highlighted in photo.
4. ‘Walk” the belt o the large pulley by
grabbing hold of the belt in the space
between the pulleys, then gently pull toward
you while turning the large pulley slowly.