8110 Automatic Coffee Machine
Instruction Manual
Page 14 of 18
4. Place a sufficient large container under the coffee spout.
5. In stand-by mode, press and hold
and the espresso button for 5 seconds. Two beeps
will be heard and the indicator
and espresso button will flash.
6. Press the espresso button
to confirm the descaling procedure. To return to standby, press
.
7.
The flashing indicator shows that the appliance is descaling. (Caution: Keep skin/body
away from the hot water.)
8. When all the water in the tank has been dispensed, the buttons
and espresso
flash. Remove all the remaining solution in the water tank and fill the tank with normal tap
water to the “max” position. Once the water tank is filled, will switch off. Then the
appliance will continue the descaling process, the appliance will brew half of water tank first
and then waiting for around 1min, after that will brew the outstanding water from the water
tank.
9. When the descaling process is completed, the appliance will switch off automatically.
Note: To ensure the descaling process can be completed, please be patient during the process
and make sure the applicant switch off automatically
II. EMPTY SYSTEM FUNCTION
The empty system function is recommended to be used before long period of non-use, frost
protection and before taking to repair agent.
1. In standby mode, press and hold and espresso buttons for 5 seconds.
2.
The indicator begins flashing.
3.
Remove the water tank from the appliance. The indicator will light up and
remain lit to indicate that the system is being emptied. You can press
before removing the
water tank to return to standby.
4.
When the empty system function is completed, the appliance will switch off automatically.
Important: After performing EMPTY SYSTEM FUNCTION; press the hot water button until water come out
from spout when the coffee maker is reused again.
To Next Page
Loading...