Brera Caffè 8110 - Troubleshooting

8110 Automatic Coffee Machine
Instruction Manual
Page 17 of 18
F. TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
The appliance does not
work.
The appliance is not
connected to the mains
supply.
- Plug in and press the on/off switch.
- Check the cable and the plug
No or delayed response in
several trials of pressing
on function key on the
panel
- Appliance is under an
electromagnetic
interference
- Dirt over the panel
- Unplug the appliance. Restart after few
minutes
- Clean the panel with the cloth provided
The coffee is not hot
enough.
- The cups have not been
preheated.
- The dispensing assembly
is too cold
-Warm the cups
- Rinse the appliance at least 3 times before
making coffee, using the coffee button
The coffee cannot come
out from spout.
Empty system function
maybe used before.
Press the hot water button until water can
come out from spout.
The first cup of coffee is
poor quality.
The first run of grinder
does not pour sufficient
quantity coffee power into
the brewing unit.
Throw the coffee away. The other coffees
will always be of good quality.
Coffee has no cream.
- Coffee bean is not fresh.
Change or use appropriate brand of coffee
bean.
The touch buttons are not
sensitive
The touch button was not
pressed correctly
Press the button with the illuminated icon
you wish to select
The appliance takes too
long time to warm up.
Excessive scale has built
up.
Descale the appliance.
The water tank is removed
/ the water level is very
low in the water tank but
indicator have no alert.
The surface where the tank
rests on the bottom of the
machine is wet
Clean and dry the bottom of the canister
compartment. Insert the canister making
sure it is pushed all the way to the bottom
The internal drip tray fills
with too much water.
Coffee powder too fine
which block the water to
come out.
Adjust the coffee fineness to bigger dot
during grinder operation.
Coffee is delivered too
slowly or a drop at a time.
Coffee powder too fine
which block the water to
come out.
Adjust the coffee fineness to bigger dot
during grinder operation.
Lack of bean indicator
flashes but there is still a
lot of coffee bean inside
the container.
Internal coffee powder
outlet is blocked.
To follow the steps of section E (V. Cleaning
coffee powder outlet).
Descaling indicator keep
flashing even perform
descaling process
The process not completed
To follow the steps of “Descaling” and make
sure the appliance switch off automatically