BRIG Eagle 8 - Page 33

2022 Owner’s Manual Eagle 8 BRIG ltd
33
How to use the toilet.
Toilet will only be active when the battery isolation switches (Fig.2b, pos.28) are ON.
The toilet uses seawater. Do not use the toilet when the boat is out of water. Or the water under the boat contains a lot of
algae and plants.
Make sure that the wastewater level indicator on the toilet control panel (15) does not show "Full".
Before using the toilet, please open hatch (10, Fig.10)) inside the cabin, open "faucet 1" (12) for water intake. The "faucet
2" (11) must be closed. For wash off the toilet, please use the toilet control panel (14) press the button "PUSH". A built-in
pump will remove waste into the wastewater tank and flush the toilet with seawater. Although the built-in pump has a
chopper, do not throw any objects into the toilet. This can clog the toilet.
After using the toilet, please close "faucet 1" (12).
KEEP CLOSED WHEN UNDER WAY. The faucet 1 (12) and faucet 2 (11) must be closed while the boat is in
motion. Sea water can fill the toilet if the faucet 1 (12) is open while the boat is in motion. Sea water can fill the
wastewater tank if the faucet 2 (11) is open while the boat is in motion.
Emptying the wastewater tank.
When waste-water level gauge on the toilet control panel (15) shows "Full" - it is time to clear wastewater tank. You may
emptying waste tank using outlet (3) on the deck. The neck (3) is labeled "WASTE". Open the cap on the neck, connect
the hose from the cleaning station. Close the cap tightly after emptying. The level gauge on the toilet control panel (15)
must shows "Lo".
If your boat is in the place where is not forbidden to drain off wastewater you may emptying waste tank in the sea.
To do this, open hatch (9) inside the cabin, open "faucet 2" (11). Outlet (3) for cleaning wastewater tank must be closed.
Push the button "WASTE PUMP" (16). The self-priming macerator (2) will begin to empty the wastewater tank overboard
through the faucet 2 (11).
When waste tank is empty, switch off the button "WASTE PUMP" (16) and close "faucet 2" (11).
The level gauge on the toilet control panel (15) must shows "Lo".