Briggs & Stratton 20228 User Manual (English)

Other manuals for Briggs & Stratton 20228

Questions and Answers:

J
James StoneJul 31, 2025
Why is my Briggs & Stratton Pressure Washer pump not building pressure?
- M
  Michael RodriguezJul 31, 2025
  If your Briggs & Stratton Pressure Washer pump fails to produce pressure, exhibits erratic pressure, chatters, loses pressure, or has low water volume, several factors could be the cause. First, ensure a high-pressure nozzle is installed instead of a low-pressure one. Check for and clear any blockages in the water inlet. Ensure an adequate water supply. Straighten any kinks or repair leaks in the inlet hose. Inspect and clean the inlet hose strainer. Verify the water supply temperature is not exceeding 100°F. Clear any blockages or leaks in the high-pressure hose. If the gun leaks, replace it. Clean any obstructions in the nozzle. If the pump remains faulty after checking these, contact an authorized service facility.
M
Michael MataAug 6, 2025
How to fix detergent not mixing in my Briggs & Stratton 20228 Pressure Washer?
- J
  Julie OneillAug 7, 2025
  If the detergent fails to mix with the spray of your Briggs & Stratton Pressure Washer, make sure the detergent siphoning tube is fully submerged in the detergent. Also, inspect the chemical filter for clogs or cracks; clean or replace the filter/detergent siphoning tube if necessary. Finally, ensure that you are using a low-pressure nozzle instead of a high-pressure nozzle.
C
Christine SaundersAug 12, 2025
How to troubleshoot a Briggs & Stratton 20228 that isn't producing pressure?
- A
  Anthony HowardAug 13, 2025
  If your Briggs & Stratton Pressure Washer fails to produce pressure, try the following: * Replace the nozzle with a high-pressure nozzle. * Clear any blockages in the inlet. * Ensure adequate water flow to the unit. * Straighten the inlet hose and repair any leaks. * Check and clean the inlet hose strainer. * Use a cooler water supply. * Clear any blockages in the outlet hose. * Clean the nozzle, or replace the gun if necessary. If none of these steps work, contact an authorized service facility.
V
varellanoAug 18, 2025
What to do if detergent doesn't mix with spray in my Briggs & Stratton 20228 Pressure Washer?
- O
  Omar LoveAug 18, 2025
  If detergent fails to mix with the spray of your Briggs & Stratton Pressure Washer, ensure the detergent siphoning tube is correctly inserted into the detergent container. Also, try cleaning or replacing the filter or detergent siphoning tube. Replace the nozzle with a low pressure nozzle. For additional guidance, see "Check In-Line Filter".
M
Misty WilsonAug 25, 2025
Why does my Briggs & Stratton Pressure Washer engine bog down under load?
- K
  Katie MunozAug 25, 2025
  If the engine of your Briggs & Stratton Pressure Washer runs well without a load but bogs down when a load is added, the engine speed may be too slow. Move the throttle control to the FAST position. If the engine still bogs down, contact a Briggs and Stratton service facility.