BRIGHT X602 - Robot Operation Modes; Operating Modes Explained; Vacuum Cleaning Modes; Smart Cleaning Mode Guide

EN
44
vacuum cleaner. The vacuum cleaner
goes automatically to the charging
station for charging.
– In standby or run mode, press the
intermediate charging button on the
remote control. The vacuum cleaner
goes automatically to the charging
station for charging.
NOTE:
• If the battery is completely discharged
and you cannot start the vacuum
cleaner, manually place the vacuum
cleaner in the charging station for
charging. The charging terminals must
be aligned with each other. Check that
the side brush is not positioned between
the terminals.
• If the start button is pressed during
ongoing charging, the charging process
is interrupted, and the vacuum cleaner
starts.
STARTING
/
STOPPING
Press the start button For 3 seconds. The start
button lights up, and the vacuum cleaner
starts.
• When the battery has discharged below
20%, the vacuum cleaner automatically
returns to the charging station for
charging.
• After completing the vacuuming, the
vacuum cleaner automatically switches to
intermediate charging mode and begins
searching for the charging station.
NOTE:
• If the vacuum cleaner stops, check the
charging status of the battery.
• The sensor range is 2 m from the
charging station. Check that the
charging station is connected to the
mains and that there are no obstacles in
the way, otherwise the vacuum cleaner
may have diculty nding the charging
station.
Start/pause/standby mode
The vacuum cleaner’s run mode changes as
follows: Sleep mode > standby mode > run
mode.
– Sleep mode: The vacuum cleaner is
in sleep mode and the status light is
o.
– Standby mode: The vacuum cleaner
is in standby mode, blue ashing
light.
– Run mode: The vacuum cleaner is
running, and the button is lit with a
constant light.
• When the vacuum cleaner is in standby
mode it automatically goes into sleep
mode after 3 minutes of no activity.
When the vacuum cleaner is in sleep
mode, press the start button to activate.
Press the start button again to start the
product.
• Pause by pressing the start button on the
product or the power on/o button on the
remote control or in the app. Pause
means that the product switches from run
mode to standby mode.
NOTE:
If the product is not going to be used for
some time, switch it o by pressing the start
button until the product switches o.
VACUUM CLEANING MODES
All vacuuming modes can be interrupted with
the start button on the vacuum cleaner.
Smart vacuum cleaning
In standby mode, press the button “Smart
cleaning” or the start button on the vacuum
cleaner. Plan the vacuuming by lling in the
lines xxxx in order, so that the entire oor
surface is covered. After completing the
vacuuming, the vacuum cleaner automatically
returns to the charging station.